Tuesday, November 26, 2013

NOKIA 1616 MIC SOLUTION 100


NOKIA 1616 MIC SOLUTION 100%


microphone components layout and tracing line paths for nokia 1800 and nokia 1616
 Nokia 1800 1616 mic jumper ways
Repair tips:
1. Check or replace a new microphone replacement before proceeding..
2. make sure that microphones contact pads is absolutely clean, a poor contact pads of the microphones terminal also cause the problem.
3. check those two filter coil near the microphones contact pads, have a continuity check between the microphones contact pads core to each corresponding filter coil. The inner layer core is the positive and the outer layer core which  is the negative.
4. Continue to check the line paths across  to microphones circuit as shown on repair guide solution above. Trace and make sure that both positive and negative line is not cut or does not have an open circuit.
5. The B+ line indicated in the guide is the microphones circuit power supply, If this said supply voltage is missing or cut also causes the microphone nonfunctional.
A poor quality audio sound signal also occurs if there is a damaged components on that part.
6. The IC component solder ball bumps that holds the microphones connection can be used to trace those lines if an internal cut or damaged occurred, when all of the above hints does not solve the problem.

0 comments:

Post a Comment

    Total Pageviews